先頭に戻る
製品の詳細
Parametric specs for Supervisors (1 Monitored Voltage)
Reset Thresh. (V) | 2.5 to 3.3 |
Reset Thresh. Accur. (%) (@ +25°C) | 2.5 |
Reset Out | Active High Active Low Push-Pull |
tRESET (min) | 85ms to 300ms |
Watchdog Feature | No Watchdog |
Supervisor Features | Manual Reset |
ICC (µA) (max) | 12 |
Package/Pins | See Data Sheet |
非表示にする
簡易ブロック図
Technical Docs
データシート | 5V/3.3V エコノモニタ | Nov 19, 1999 |
パラメーター
Parametric specs for Supervisors (1 Monitored Voltage)
Reset Thresh. (V) | 2.5 to 3.3 |
Reset Thresh. Accur. (%) (@ +25°C) | 2.5 |
Reset Out | Active High Active Low Push-Pull |
tRESET (min) | 85ms to 300ms |
Watchdog Feature | No Watchdog |
Supervisor Features | Manual Reset |
ICC (µA) (max) | 12 |
Package/Pins | See Data Sheet |
主な特長
- Halts and restarts an out-of-control microprocessor
- Holds microprocessor in check during power transients
- Automatically restarts microprocessor after power failure
- Monitors pushbutton for external override
- Accurate 5%, 10%, or 20% (3V only) microprocessor power monitoring
- Eliminates the need for discrete components
- 20% tolerance for use with 3.0V systems
- Pin- and function-compatible with the MAX823/24/25 products
- Low cost SOT-23-5 package
- Industrial temperature range: -40°C to +85°C
アプリケーション/用途
説明
The DS1814 5-Volt MicroMonitor and the DS1819 3.3V MicroMonitor monitor three vital conditions for a microprocessor: power supply, software execution, and external override. First, a precision temperature-compensated reference and comparator circuit monitor the status of VCC. When an out-of-tolerance condition occurs, an internal power-fail signal is generated which forces the reset(s) to an active state. When VCC returns to an in-tolerance condition, the reset signal is kept in the active state for a minimum of 140ms to allow the power supply and processor to stabilize. The DS1814/DS1819 ‘A' and ‘C' perform pushbutton reset control. They debounce the pushbutton input and generate an active reset pulse width of 140ms minimum. The DS1814/9 'A' and 'B' versions perform a watchdog function. The watchdog is an internal timer that forces the reset signals to the active state if the strobe input does not change state every 1.12 seconds. The watchdog timer function can be disabled by leaving the watchdog strobe input disconnected.
Technical Docs
データシート | 5V/3.3V エコノモニタ | Nov 19, 1999 |