回到顶部

5V及3.3V MicroMonitor

产品详情

主要特征

Parametric specs for Supervisors (1 Monitored Voltage)
Reset Thresh. (V) 2.5 to 3.3
Reset Thresh. Accur. (%) (@ +25°C) 2.5
Reset Out Active Low
Push-Pull
tRESET (min) 85ms to 300ms
Watchdog Feature Input (WDI)
Watchdog Timeout 1s to 2s
Supervisor Features Manual Reset
ICC (µA) (max) 12
Package/Pins See Data Sheet
缩小

简化框图

Technical Docs

数据资料 5V及3.3V MicroMonitor Nov 19, 1999

支持和培训

在Maxim的知识库中搜索技术问题的答案

过滤搜索

Maxim的专业工程师团队也会为您解答相应的技术问题,请访问Maxim的 支持中心

参量

Parametric specs for Supervisors (1 Monitored Voltage)
Reset Thresh. (V) 2.5 to 3.3
Reset Thresh. Accur. (%) (@ +25°C) 2.5
Reset Out Active Low
Push-Pull
tRESET (min) 85ms to 300ms
Watchdog Feature Input (WDI)
Watchdog Timeout 1s to 2s
Supervisor Features Manual Reset
ICC (µA) (max) 12
Package/Pins See Data Sheet

主要特征

  • Halts and restarts an out-of-control microprocessor
  • Holds microprocessor in check during power transients
  • Automatically restarts microprocessor after power failure
  • Monitors pushbutton for external override
  • Accurate 5%, 10%, or 20% (3V only) microprocessor power monitoring
  • Eliminates the need for discrete components
  • 20% tolerance for use with 3.0V systems
  • Pin- and function-compatible with the MAX823/24/25 products
  • Low cost SOT-23-5 package
  • Industrial temperature range: -40°C to +85°C

应用/用途

描述

The DS1814 5-Volt MicroMonitor and the DS1819 3.3V MicroMonitor monitor three vital conditions for a microprocessor: power supply, software execution, and external override. First, a precision temperature-compensated reference and comparator circuit monitor the status of VCC. When an out-of-tolerance condition occurs, an internal power-fail signal is generated which forces the reset(s) to an active state. When VCC returns to an in-tolerance condition, the reset signal is kept in the active state for a minimum of 140ms to allow the power supply and processor to stabilize. The DS1814/DS1819 ‘A' and ‘C' perform pushbutton reset control. They debounce the pushbutton input and generate an active reset pulse width of 140ms minimum. The DS1814/9 'A' and 'B' versions perform a watchdog function. The watchdog is an internal timer that forces the reset signals to the active state if the strobe input does not change state every 1.12 seconds. The watchdog timer function can be disabled by leaving the watchdog strobe input disconnected.

简化框图

DS1814、DS1819:原理框图 DS1814、DS1819:原理框图 Zoom icon

Technical Docs

数据资料 5V及3.3V MicroMonitor Nov 19, 1999

支持和培训

在Maxim的知识库中搜索技术问题的答案

过滤搜索

Maxim的专业工程师团队也会为您解答相应的技术问题,请访问Maxim的 支持中心