DS2450

1-Wire Quad A/D Converter

 Overview   Design Resources   Ordering Info   All   

Status Explanations for product status codes

Part Number Status Explanation
DS2450 This product is No Longer Available. See Ordering Information for recommended replacements.DS2450 is available only for existing customers due to process nonavailability for new builds. 

Description

The DS2450 1-Wire® Quad A/D Converter is based on a successive-approximation analog to digital converter with a four to one analog multiplexer. Each input channel has its own register set to store the input voltage range, resolution, and alarm threshold values as well as flags to enable participation of the device in the conditional search if the input voltage leaves the specified range. Two alarm flags for each channel indicate if the voltage measured was too high or too low without requiring the bus master to do the comparison. Each A/D conversion is initiated by the bus master. A channel not used as analog input can serve as a digital open-drain output. After disabling the input the bus master can directly switch on or off the open-drain transistor at the selected channel. All device settings are stored in SRAM and kept non-volatile while the device gets power either through the 1-Wire bus or through its VCC pin. After powering up, a power-on reset flag signals the bus master the need to restore the device settings before the regular operation can resume. All device registers and conversion read-out registers are organized as three 8-byte memory pages similar to the Status Memory of a DS2505/6 device. An on-chip CRC16 generator protects the communication against transmission errors when reading through the end of a memory page as well as when writing individual bytes.

Data Sheet

Download this datasheet in PDF formatDownload Rev 3 (PDF, 708kB)
Send this datasheet to any email addressEmail

My Maxim: Not Logged In
By logging in to My Maxim you can subscribe to alerts for this data sheet.

Login | Register

Key Features

  • Four high-impedance inputs to measure analog voltages over the 1-Wire bus
  • User programmable input range (2.56V, 5.12V), resolution (1 to 16 bits) and alarm thresholds
  • 5V, single supply operation
  • Very low power: 2.5mW active, 25µW idle
  • Built-in multidrop controller allows multiple DS2450's to be identified and operated on a common 1-Wire bus
  • Responds to Conditional Search if the analog voltage crosses the alarm thresholds
  • Channels not used as analog input can serve as open drain digital outputs for closed-loop control
  • Directly connects to a single port pin of a microprocessor and communicates at up to 16.3k bits per second
  • Overdrive mode boosts communication speed to 142k bits per second
  • On-chip 16-bit CRC-generator for safeguarding data transfers
  • Unique, factory-lasered and tested 64-bit registration number (8-bit family code + 48-bit serial number 8-bit CRC tester) assures absolute traceability because no two parts are alike
  • 8-bit family code specifies device communication requirements to bus master
  • Operating temperature range from -40°C to +85°C
  • Compact, low cost 8-pin SOIC surface mount package
   
   

Diagram

DS2450: Block Diagram
Block Diagram

Didn't Find What You Need?

Information Index

Overview

 

Design Resources

 

Ordering Info

 

Related Products

 
Description
Key Features
Applications/Uses
Key Specifications
Diagram
Notes and Comments
  Data Sheet
Technical Documents
Evaluation Kits
Reliability Reports
Software/Models
  Price and Availability
Samples
Buy Online
Package Information
Lead-Free Information
  Similar Products by Function
Similar Products by Application
Evaluation Kits
Products with Similar Part Numbers
Products Used With This
 
Rev 3; 2006-11-27
This page last modified: 2009-10-15